Baud Rate of 19200 or 38400 should work.Click the Open… button, and then use the file selection dialog to select the ic-7300.xml file you just uploaded in step 3. The Rig Description File box should be blank.Click the user RigCat checkbox at the top of the box.Select RigCAT from the left tab on the 2nd line.Install fldigi by running the file you downloaded.Keep track of where you save that file for use in Step 5. So, you need to download the rig description file from here: ic-7300.xml before you install fldigi. The specific rig description is available for the IC-7300 to download. Instead, you use the fldigi RigCAT settings. Some transceivers can work with the (not recently updated) Hamlib library, but not the IC-7300. Each transceiver needs a Rig definition.Download fldigi from here: fldigi – Ham Radio Digital Modem Application.Setup your 7300 as described in this post Icom IC-7300 Digital Mode Settings.This post describes the steps needed to get fldigi set up with the Icom IC-7300. It seems to have become the goto reference page for setting up fldigi for the Icom IC-7300, and I will try to keep it updated. This setup will still work correctly with WSJT-X.ĭXLab has a page explaining how to setup the waterfall display here.įldigi is a free program used for various digital modes. On the other hand, the DXLab Suite rig driver needs the CV-I USB Port set to “ Unlink from ” which allows it to run at 115200 baud and thus support the waterfall display. How to recreate this situation is not clear, but it can happen. But the higher rates don’t work – 19200 is still the maximum. There seems to be a bug in the V1.20 IC-7300 firmware that can still show higher baud rates even when “ Link to ” is select. When “ Link to ” is selected, the CI-V USB Baud Rate will max out at 19200. This is because those settings require setting the CV-I USB Port setting to “ Link to ” which imposes the 19200 baud limit. If you use the WSJT-X native IC-7300 settings, 19200 is the maximum baud rate you can select. To use this effectively, this means running the serial port at 115200 baud. One the big advantages of using DXLab Commander is its ability to show the IC-7300 waterfall spectrum display on you computer monitor. You can even setup DXLab Launcher to do this automatically. Then run Commander first, followed by WSJT-X. Setup WSJT-X to use DXLab Commander CV-I Driver You cannot use both the native IC-7300 setup for WSJT-X and Commander at the same time.įortunately, you can still use both at the same time by selecting the DXLab Suite as the radio selection from the WSJT-X Config screen. If you use both WSJT-X and DXLab Suite Commander, you will find that both of these programs need to use the serial CI-V interface to your IC-7300.
0 kommentar(er)
